User guide

Cabling
3 To make the network connection, connect one end of an
RJ-45 (UTP) cable to the 10 BASE-T connector on the back
of the ProxyServer as shown in Figure 3. Connect the other
end of the cable to your LAN.
4 Connect one end of an RJ-45 cable to the ISDN
connector on the back of the unit and connect the other
end to the ISDN Telephone Network (Telco wall jack) as
shown in Figure 3.
5 If desired, connect an analog phone set to the PHONE
jack on the back panel of the ProxyServer.
6 Turn on power to the ProxyServer by setting the ON/OFF
switch on the back panel to the ON position. Wait for the
red Fail LED on the ProxyServer to go OFF before
proceeding. This may take up to two minutes to go
OFF.
At this time your ProxyServer is completely cabled and
powered on. Proceed to the next section to load your Proxy-
Server software.
9