Network Router User Manual

MultiFRAD 3000-Series User Guide

If your network protocol is IPX, continue with the following steps. If you are not using IPX

routing, click on IPX Routing Enable check box to disable IPX, then click on the OK

button, and proceed to step 13.

9. Router Name: You can use the default Router Name or you can assign a new Router Name

in this field. If you assign a new Router Name, it must be a printable ASCII string of a

maximum of 47 characters. The router name is used by the MultiFRAD to advertise its

service in the IPX inter-network.

10. Ethernet: You can enable Auto Learn Network Numbers by leaving the default Yes or you

can manually assign the network numbers by clicking on No in the Auto Learn Network

Numbers field.

If no file server is connected to the Ethernet segment, then this field should be No

(recommended).

If you enable Auto Learn (Yes), the MultiFRAD will learn the IPX network numbers from the

file server.

If you select No for Auto Learn, record the network numbers assigned by the network file

server for each of the four frame types (Raw (802.3), LLC (802.2), EthernetII (Type II),

SNAP) in the space provided below.

RAW (802.3) Frames Network Number _____________

LCC (802.2) Frames Network Number ______________

TYPE_II Frames Network Number _________________

SNAP Frames Network Number ___________________

WAN Network Number __________________________

When you manually assigning network numbers, you must make sure they match the

network numbers assigned to your local file server (if any).

11. WAN: Enter the WAN network number for the Frame Relay WAN Port by clicking on the

Network Number box and back spacing through the default number and entering your new

WAN Number. Make sure the WAN network number is the same as the MultiFRAD on the