Network Router User Manual

50
MultiFRAD 3000-Series User Guide
To map a new DLCI (e.g., 17) to a protocol, return to the Main Menu and then click on the protocol
stack that you are using. In the lower left part of the protocol stack dialog box a list of Logical WANs
is displayed. To add a new logical WAN, click on the Add (+) button and the next logical WAN
number will appear in the list on the left hand side of the dialog box.
For example lets map our new DLCI 17 to the IP protocol as a WAN 2 with an IP Port Address of
200.2.11.1, an IP Mask of 255.255.255.0, and a remote IP Address of 200.2.11.2. From the Main
Menu, click on the IP button. The IP Setup dialog box is displayed. Click on the WAN tab at the top
of the dialog box. The WAN parameters are displayed. Click on the Add (+) button and WAN 2 is
added to the List of Logical WANs. Default IP addresses will be displayed for the Port Address and
Remote Address and a default IP Mask will appear in its window. If either address or mask needs to
be changed, click on the appropriate window and the change the numbers.
When you click on the OK button in the IP WAN dialog box, you now have an IP address for a
second logical WAN. Now we have to tie that IP address to a DLCI which in our example is DLCI 17.
Now, return to the Frame Relay DLCI dialog box and high light DLCI 17. Click on the Protocol
Mappings Map IP Address down arrow and the IP address 200.2.11.1 appears. Click on this address
and now IP address 200.2.11.1 is mapped to DLCI 17.