Specifications

Chapter 2 – Getting Started
MultiModem® iSMS Administrator’s Guide 18
SF 400/800 Cabling
1. Plug one end of a RJ-45 cable into the LAN port on the MultiModem iSMS and the other end into your network or
workstation interface.
2. Attach the cellular antennas.
3. Connect the provided power supply cable to the 9 volt power port on the back of the MultiModem iSMS, and plug
the other end into an AC power outlet. The unit’s front panel Status and LAN LEDs report normally approximately 30
seconds after power is applied. Refer to Chapter 1, Front Panel LEDs.
Antenna Notes:
● Be sure to locate this appliance where there is wireless coverage.
● The antenna must be attached in order for the MultiModem iSMS to be operational.
● Maintain a separation distance of at least 20 cm (8 inches) between the transmitter’s antennas and the body of the
user or nearby persons. The product is not designed for, nor intended to be, used in applications within 20 cm (8
inches) of the body of the user.