Technical data

LU940407

6. Mai 1992 @ 12:49 Uhr

Footswitches / "SONGS"

Main menu:

View of the rear:

Function keys (F1 - F4) on the front of the MS-8

Footswitches / "SONGS"

After factory setup the four footswitches

are set to "SONG" up and down and "STEP"

up and down. To change this you have to

enter the SONG/FOOTSW. menu.

2 To setup the footswitches

You have to enter the SONGS/FOOTSW. menu.

(From the "PLAY" menu: Press the CURSOR key [ ] twice.)

To jump into the menu press the CURSOR key [ ] once.

The value above the CURSOR, can be changed with one of the CURSOR keys [ ]

or [ ], until the desired mode is achieved.

With one of the CURSOR keys [ ] or [ ] you can change the position of the

CURSORS to activate.

Also you can select the desired footswitch with the key SWITCHES (1-8).

ATTENTION: If you do not use the optional RC-8 remote controller you can not use

the

footswitches 5 to 8.

Easy programming with the function keys (F1-F4) :

- F1 = Change the function of the footswitch (1 - 10)

- F2 = Change the function of the footswitch (10 - 1)

- F3 = Counts the values up

- F4 = Counts the values down

Note: Only using the"EXIT" key to leave the menu will store the changes into the

internal memory. If you switch the MS-8 off

before pressing the "EXIT" key the

MS-8 can not write into the internal memory and the data is lost.

TIP: The ground of the four footswitches is on the same wire, so that you can put

them on together one side if you want to build your own footswitch.