Technical data

LU940407

6. Mai 1992 @ 12:49 Uhr

1 F-AMP SETUP

Rear of the MS-8

The connection to these amps are located on the rear of the MS-8.

At first you have to set the "ASSIGN" SWITCH also on the rear to the correct position.

Setup the "ASSIGN" SWITCH:

For all F-AMPS with 1 to 3 buttons on the included footswitch set "ASSIGN" to position

"1...3"

For all F-AMPS with 4 buttons on the included footswitch set "ASSIGN" to position

"4-Button".

You have to select the correct type of your F-AMP in the menu SWITCH/F-AMP

After this procedure you always get the correct menu on the LC-DISPLAY.

To jump into the SWITCH/F-AMP menu you must press the CURSOR key [ ] once.

Press the the CURSOR key [ ] several times until you get the menu.

Then select the correct type and leave the menu by using the "EXIT" key.

2 List of the F-Amps / New generation.

Released June 1992

To switch a connected F-AMP you have to select the F-AMP OUT menu: