Technical data

25
LU940407
6. Mai 1992 @ 12:49 Uhr
Overview for advanced users
Overview for advanced user
"WRITE PROTECT""HELLO" message F-AMP type Function of the
Relays
"SWITCHES 1 - 8"
10 different
footswitch modes
100 "SONGS"
with
8 "STEPS"
MIDI OUT
TRANSMIT
and RECEIVE
CHANNEL
MIDI MAPPING
Global data stored in the MS-8
STEP -ABSOLUTE 1 to 8 Recall the selected STEP
STEP -RELATIVE -1 to +1 Counts a STEP up or down
PR
(ogram) - TOUCH 1 to 128 Recall the selected PROGRAM (*1)
M (I) D (I) -TOUCH 1 to 128 Recall the MIDI data of a PROGRAM (*1)
SWITCH -TOUCH 1 to 8 Switches relays (Momentary function!) (*1)
SWITCH -TOGGLE 1 to 8 Switches relays (Latch function!)
(*1) = (Touch means: works the time during a key will be pressed)
SWITCH/ F-AMP:
The menu to configure the relays to emulate different kinds of switches.
Each relay can emulate:
POS. SWITCH Relays is closed if the LED of the SWITCH is on
NEG. SWITCH Relays is open if the LED of the SWITCH is on
POS. PULSE Relays is closed for a specific time (t=???).
NEG. PULSE Relays is open for a specific time (t=???).
SWITCH/ F-AMP:
In this menu you can select the correct menu of your F-AMP. The "ASSIGN" slide
switch on the rear of the MS-8 must be set to the correct position!
MIDI SETUP:
MIDI IN: To select the MIDI RECEIVE CHANNEL 1-16, OMNI, or OFF.
MIDI IN PRG.: To select which internal PROGRAM (1-128) of the MS-8 will be
selected, when it receives MIDI PROGRAM CHANGES. (= MIDI MAPPING!)
MIDI OUT: To configure the count (1 to 5) of the internal MIDI TRANSMIT
CHANNELS 1-16 or OFF.
MIDI SETUP: Resets the global MIDI data to the "FACTORY SETUP".
With safety question: "ARE YOU SURE?" (Are you really sure??)
HELLO MESSAGE:
In this menu you can give your MS-8 a name or something else. You can use up to 16
characters.
This message will be appear on the LC-DISPLAY for approx.. 2 seconds after power up.