Installation Guide

E.L. MUSTEE & SONS, INC.
5431 West 164th Street • Cleveland, Ohio 44142
SI-193 (12
•
04)
CARE AND CLEANING:
The surface of your Durawall
®
Fiberglass Bathtub Walls may be cleaned with a mild soap solution in warm water using a
soft cloth. For stubborn stains use “Soft-Scrub” by Clorox or Lysol “Tub & Tile Cleaner” or a powdered detergent such as
“Spic-n-Span.” Never use abrasive scouring powder or steel wool pads as they will scratch the surface. A periodic coating
of silicone based marine polish will help retain the fine finish.
Warning:
Do not use spray-on cleaners that require daily use without immediately rinsing to stop chemical reaction. Damage will
result and void warranty.
MODEL 300.600W
WINDOW TRIM KIT
(SOLD SEPARATELY)
•5 - PC. FIBERGLASS KIT ACCOMMODATES
WINDOWS UP TO 36” WIDE X 8” DEEP.
• SMOOTH, EASY TO INSTALL PANELS
PROVIDE WATERPROOFING FOR
WINDOWS IN BATHTUB ALCOVE.
MUSTEE
DURAWALL
®
5 PC. BATHTUB WALLS
INSTALLATION INSTRUCTIONS
MODEL 557
FIBERGLASS
5. Clean any excess adhesive immediately with
mineral spirits, then wash area with a soap
and water solution to neutralize solvent. Allow
adhesive to cure for 24 hours before proceeding.
6. Caulk around all edges and seams using a
quality “tub & tile” sealant. Remember to caulk
around faucet spout and handle hole(s). Replace
all plumbing fixtures and allow caulk to cure
before using tub or shower.