Installation Guide

ManualsBrandsMustee ManualsBathtubsT6030RBT

INSTALLATION INSTRUCTIONS

INSTRUCCIONES PARA LA INSTALACIÓN

INSTRUCTIONS D’INSTALLATION

SI-208 (12-14)

Patented and patents pending. Made and Printed in U.S.A.

Patentes y patentado pendientes. Hecho e impreso en U.S.A.

Breveté et brevets en attente. Fabriqué et imprimé aux États-Unis

* Part No. Color Type

Nro. de pieza Color Tipo

N° de référence Couleur Type

T6030L White Left

Blanco Izquierda

Blanc Gauche

T6030R White Right

Blanco Derecho

Blanc Droite

T6030LBN Bone Left

Hueso Izquierda

Crème Gauche

T6030RBN Bone Right

Hueso Derecho

Désosser Droite

READ ALL INSTRUCTIONS CAREFULLY AND INSPECT PRODUCT FOR DAMAGE BEFORE STARTING YOUR INSTALLATION.

LEA TODAS LAS INSTRUCCIONES DETENIDAMENTE Y VERIFIQUE QUE EL PRODUCTO NO ESTÉ DAÑADO ANTES DE COMENZAR LA INSTALACIÓN.

VEUILLEZ LIRE ATTENTIVEMENT TOUTES LES INSTRUCTIONS ET VÉRIFIER QUE LE PRODUIT N’EST PAS ABÎMÉ AVANT DE PROCÉDER À L’INSTALLATION.

INCLUDED IN CARTON: EN EL PAQUETE SE INCLUYE: CONTENU :

One (1) bathtub Una (1) bañera Une (1) baignoire

Six (6) mounting clips Seis (6) abrazaderas Six (6) ﬁxations

Instructions Instrucciones Instructions

TOOLS AND MATERIALS REQUIRED FOR INSTALLATION:

HERRAMIENTAS Y MATERIALES PARA LA INSTALACIÓN DEL PRODUCTO:

OUTILS ET MATÉRIEL NÉCESSAIRES À L’INSTALLATION :

Hammer Martillo Marteau

Screwdriver Destornillador Tournevis

Tape measure Cinta métrica Mètre ruban

Level (24" min.) Nivel (24" min.) Niveau (24 po min.)

Pencil Lápiz Crayon

1" x 4" support rails

(6–7 ft. pine)

Rieles de soporte de 1" x 4"

(pino de 6–7 pies.)

Rails d’appui 1 x 4 po

(pin 6 à 7 pieds)

Mounting screws (#8 x 1

" min.) Tornillos de sujeción (Nro. 8 x 1

" min.) Vis de ﬁxation (8 x 1,5 po min.)

Shims (optional) Cuñas (opcional) Cales (facultatif)

Felt paper or mortor cement Papel de ﬁeltro o mortero de cemento Papier-feutre ou ciment à maçonner

Silicone sealant Impermeabilizador de silicona Mastic silicone

Models:

Modelos:

Modèles:

T6030

TOPAZ

™

30" x 60" Bathtub

Bañera TOPAZ

™

de 30" x 60"

Baignoire TOPAZ

™

de 30 x 60 pouces

E.L. Mustee & Sons, Inc.

5431 West 164th St.

Brook Park, OH 44142

Phone: 216.267.3100

Fax: 216.267.9997

Email: info@mustee.com

Web: www.mustee.com

Summary of content (12 pages)

PAGE 1
E.L. Mustee & Sons, Inc. 5431 West 164th St. Brook Park, OH 44142 INSTALLATION INSTRUCTIONS INSTRUCCIONES PARA LA INSTALACIÓN INSTRUCTIONS D’INSTALLATION n Models: Modelos: Modèles: T6030 * Phone: 216.267.3100 Fax: 216.267.9997 Email: info@mustee.com Web: www.mustee.com TOPAZ 30" x 60" Bathtub ™ Bañera TOPAZ™ de 30" x 60" Baignoire TOPAZ™ de 30 x 60 pouces UP C n R Read all instructions carefully AND INSPECT PRODUCT FOR DAMAGE before starting your installation.
PAGE 2
E.L. Mustee & Sons, Inc. 5431 West 164th St. Brook Park, OH 44142 INSTALLATION INSTRUCTIONS INSTRUCCIONES PARA LA INSTALACIÓN INSTRUCTIONS D’INSTALLATION n Models: Modelos: Modèles: T6030 * Phone: 216.267.3100 Fax: 216.267.9997 Email: info@mustee.com Web: www.mustee.com TOPAZ 30" x 60" Bathtub ™ Bañera TOPAZ™ de 30" x 60" Baignoire TOPAZ™ de 30 x 60 pouces UP C n R READ ALL INSTRUCTIONS CAREFULLY AND INSPECT PRODUCT FOR DAMAGE BEFORE STARTING YOUR INSTALLATION.
PAGE 3
RouGH-IN fRaMING eNCuadRe PReLIMINaR n SCHÉMa de MoNTaGe NoTe: (Fig. 1) refers to installing a standard bathtub with below ﬂoor drain. Requires standard drain and overﬂow assembly (not included). Left-hand drain shown – reverse for right-hand drain installation. fig. 1 NoTa: En la (Fig. 1) se muestra la instalación de una bañera estándar con drenaje en el suelo. Debe colocarse un dispositivo estándar para drenaje y desbordamiento (no se incluye).
PAGE 4
PREPARATION: NEW CONSTRUCTION Before beginning, remove the new bathtub from carton and inspect for damages. Determine the location for the Mustee TOPAZ™ bathtub and construct the alcove to the dimensions in (Fig. 1). Plan rough plumbing requirements (drain-venting-supply lines) at this time according to local building code. Additional bracing to support optional grab bars and/or seat should be installed at this time. Refer to the accessory manufacturer’s instructions for proper installation. Go to step 1.
PAGE 5
3 STEP 2: PASO 2: Per the “ROUGH-IN FRAMING” illustration, cut a 5" x 11" opening in the sub-floor or slab, located on a 141/4" center-line from the back wall of alcove for either the right or left drain. (Fig. 1) ÉTAPE 2 : Observe la ilustración de la sección “ENCUADRE PRELIMINAR” y luego haga una abertura de 5" x 11" en la base del suelo o losa, en el centro y a una distancia de 141/4" con respecto a la pared posterior del nicho, para colocar el desagüe sobre el lado derecho o izquierdo. (Fig.
PAGE 6
fig. 3 fig. 4 *1 Mounting Clip actual Size *3 *1 *2 Cuadro 3 Le schéma 3 Cuadro 4 Le schéma 4 *1 Tamaño real del gancho de montaje *1 Taille réelle de la fixation *1 Abrazaderas *2 Bañera *3 Tornillos de sujeción *1 Fixation *2 Baignoire *3 Vis de fixation STeP 6: PaSo 6: ÉTaPe 6 : After the bathtub is level, install the (6) six mounting clips on the flange of bathtub as shown in (Fig. 3, 4) and in the locations in (Fig. 1).
PAGE 7
Do not allow cleaners to sit or soak on the surface. Wipe surface clean and rinse completely with water immediately after cleaner application. Rinse and dry any overspray on nearby surfaces. Never use abrasive scouring powder or steel wool pads, as they will scratch the surface. A periodic coating of a high quality marine or automotive polish will help retain the finish. No deje que los productos de limpieza descansen sobre la superficie.
PAGE 8
ROUGH-IN FRAMING ENCUADRE PRELIMINAR n SCHÉMA DE MONTAGE NOTE: (Fig. 1) refers to installing a standard bathtub with below floor drain. Requires standard drain and overflow assembly (not included). Left-hand drain shown – reverse for right-hand drain installation. Fig. 1 NOTA: En la (Fig. 1) se muestra la instalación de una bañera estándar con drenaje en el suelo. Debe colocarse un dispositivo estándar para drenaje y desbordamiento (no se incluye).
PAGE 9
PREPARATION: NEW CONSTRUCTION Before beginning, remove the new bathtub from carton and inspect for damages. Determine the location for the Mustee TOPAZ™ bathtub and construct the alcove to the dimensions in (Fig. 1). Plan rough plumbing requirements (drain-venting-supply lines) at this time according to local building code. Additional bracing to support optional grab bars and/or seat should be installed at this time. Refer to the accessory manufacturer’s instructions for proper installation. Go to step 1.
PAGE 10
3 STEP 2: PASO 2: Per the “ROUGH-IN FRAMING” illustration, cut a 5" x 11" opening in the sub-floor or slab, located on a 141/4" center-line from the back wall of alcove for either the right or left drain. (Fig. 1) ÉTAPE 2 : Observe la ilustración de la sección “ENCUADRE PRELIMINAR” y luego haga una abertura de 5" x 11" en la base del suelo o losa, en el centro y a una distancia de 141/4" con respecto a la pared posterior del nicho, para colocar el desagüe sobre el lado derecho o izquierdo. (Fig.
PAGE 11
Fig. 3 Fig. 4 *1 Mounting Clip Actual Size *3 *1 *2 Cuadro 3 Le schéma 3 Cuadro 4 Le schéma 4 *1 Tamaño real del gancho de montaje *1 Taille réelle de la fixation *1 Abrazaderas *2 Bañera *3 Tornillos de sujeción *1 Fixation *2 Baignoire *3 Vis de fixation STEP 6: PASO 6: ÉTAPE 6 : After the bathtub is level, install the (6) six mounting clips on the flange of bathtub as shown in (Fig. 3, 4) and in the locations in (Fig. 1).
PAGE 12
Do not allow cleaners to sit or soak on the surface. Wipe surface clean and rinse completely with water immediately after cleaner application. Rinse and dry any overspray on nearby surfaces. Never use abrasive scouring powder or steel wool pads, as they will scratch the surface. A periodic coating of a high quality marine or automotive polish will help retain the finish. No deje que los productos de limpieza descansen sobre la superficie.