Manual

Page 10

7. Connect the 12 VDC power supply first to the receiver and then plug the power

supply into an AC power outlet. If power is present, then the green power LED

will be ON.

8. To adjust the picture quality, toggle the gain adjustment DIP switches on the rear

panel of the receiver. The factory default position is “all OFF” (up position).

1 2 3 4

Figure 5: DIP switches for gain adjustment

The following table provides suggested DIP switch settings.

Table 1: DIP switch settings

Distance (ft) Switch 1 Switch 2 Switch 3 Switch 4

50 OFF OFF OFF OFF

100 OFF OFF OFF ON

150 OFF OFF OFF ON

200 OFF OFF ON OFF

250 OFF ON OFF OFF

300 ON OFF ON ON

350 ON ON OFF ON

400 ON ON ON OFF

450 ON ON ON ON

500+ ON ON ON ON

Note: For display equipment with automatic gain control (for example, certain

models of projectors), complete all installation procedures and ensure that all DIP

switches are OFF before turning the display equipment on. Otherwise, the display

could override the adjustable gain feature of the VideoEase Active VGA Balun Kit.