Manual

Page 9

3.3. Pre-Installation Checklist

There are two components: the transmitter and the receiver.

1. The transmitter is connected to the video source, usually a PC, by a VGA

jumper cable (not included).

2. The transmitter is connected to the receiver by Category 5 (or higher) UTP

cable (not included).

3. A monitor can be connected to the transmitter by a VGA jumper cable (not

included).

4. The receiver is connected to the display equipment, usually a projector or

screen, by a VGA jumper cable (not included).

5. The both transmitter and receiver must be powered by a 12 VDC external

power supplies (included).

6. Verify that the desired image resolution is supported by the VGA source and

VGA display.

3.4. Installation Procedure

Verify that the distance between the VGA transmitter and receiver are within

MuxLab specifications (see Technical Specifications). In order to install the

transmitter, please follow the steps below:

1. Connect the transmitter to the video source with a VGA jumper cable.

2. Connect a length of Category 5 (or higher) UTP cable to the transmitter.

3. (Optional) Connect a local monitor to the transmitter with a VGA jumper cable.

4. Connect the 12 VDC power supply first to the transmitter and then plug the

power supply into an AC power outlet. If power is present, then the green

power LED will be ON.

To install the receiver, please follow the steps below:

5. Connect the receiver to the display equipment with a VGA jumper cable.

6. Connect the UTP cable to the Video IN/UTP connector of the receiver.