Operation Manual

09
HI-LINE RC & HI-LINE RC Heater/Cooler
11.0 Operating Instructions
Description
This HI-LINE unit is fitted with a control system that provides 3
different operating modes. In automatic mode the desired
temperature set point is selected and the unit will adjust the fan
speed according to the difference between the actual room
temperature and the set point. When the room temperature
reaches the set point the fan will switch off and thereafter will
continue to cycle on and off to maintain the room temperature.
The temperature set point range is 15 - 35°C.
In manual mode the automatic temperature control is over
ridden and any of the three fan speeds can be operated
inrespective of the water temperature in the unit. This means
that air circulation can be provided in summer for example, or
that heating performance can be controlled manually.
In manual mode, with water temperature control, any of the 3
fan speeds can be selected and the fan will operate when the
water temperature in the coil is greater than 32°C. This means
that heating performance can be controlled manually, and the
unit could be controlled via an external room thermostat.
The unit can be controlled using the infra red remote control
handset supplied with the unit (see fig. 5) and also using the
control panel on the unit (see fig. 6). If necessary, however, the
control panel can be locked electronically to prevent tampering
once the controls have been set (see over).
The remote control hand set takes 2 AAA batteries (not supplied).
Fig. 5 Fig. 6
Controls Display
Power button Switches unit on & off
‘+/-’ button Adjust temperature set point from
15 - 35°C
Scrolls into F1, F2 or F3 manual mode
Heating
The unit will only operate in heating mode when the central
heating boiler is on, the pump is running and the system
water temperature is greater than 32°C. Ensure the boiler is
on, and set timer, boiler controls and room thermostats as
necessary.
10.0
11.0
23673 HiLine manual UK 27/06/2011 09:12 Page 10