Operation Manual

2 To select other channels, toggle [ ] to step through the channel list.
Release [ ] when you have arrived at your desired channel. Press
[ENTER] to tune the selected channel.
• Channel and frequency are shown in the lower line of the VFD.
The number of “o” display at the upper line of the VFD indicates
the signal strength level of the current channel. To improve the
reception of the selected channel, adjust or reposition the DAB
antenna until the best reception is indicated.
ooooo�����������
�5A��174.928MHz�
• If the manually tuned channel and frequency are not available, “No
Service List” will be shown in VFD.
NOTE
The number of ensembles and stations that could be scanned will vary
depending upon your location.
PRUNE LIST
There maybe situations wherein certain stations become inactive. The
“Prune list” option enables the deletion of these inactive stations in the
service list.
1 While listening to a DAB broadcast, press [TUNER MODE] button and
then [ ] to select “Prune list”.
DAB�������������
<Prune�list����>
2 Press [ENTER]. Use [ ] and then press [ENTER] to select between
“Cancel” or “OK? [SELECT]”. Any inactive stations (normally preceded by
a “?” mark) are automatically deleted when “OK? [SELECT]” is selected.
Otherwise, select “Cancel”.
DAB�������������
<OK?[SELECT]���>
DAB RESET
The “DAB reset” option enables the re-initializing of the NAD DAB Adaptor
by going to Full Scan mode.
1 While listening to a DAB broadcast, press [TUNER MODE] button and
then [ ] to select “DAB reset”. Press [ENTER].
DAB�������������
<DAB�reset�����>
2 The VISO THREE will initiate “DAB reset” and immediately go on to “Full
Scan” mode thereby enabling the VISO THREE to re-scan again the full
range of available DAB broadcasts.
IMPORTANT NOTICE
When “DAB reset” option is selected, all stored DAB presets will be
erased.
SETTING DAB PRESETS
The VISO THREE can store as many as 99 DAB stations of your favorite DAB
broadcast for immediate recall.
1 To store a DAB preset, rst tune the DAB broadcast, and then press the
VR3’s panel [MEMORY] button (DEVICE SELECTOR must be set “TUN”).
The VFD will show “Preset Memory --”; “--” is blinking waiting for a Preset
number to be assigned.
2 Enter a Preset number in two ways
- Directly enter a number between 1 to 99 and then press [MEMORY]
button.
- Toggle [ ] or PRESET [ ] to step through the Preset
numbers, stop at desired number and then press [MEMORY].
Your desired DAB broadcast is now stored in the assigned preset.
DAB�������������
Preset�memory�01
3 Press [ ] or PRESET [ ] to step up or down between
presets. Stop at desired Preset number. Note that Presets must have
been previously stored.
DELETING A DAB PRE SET
The procedure for deleting a DAB preset or all DAB Presets is the same as
that of deleting AM/FM Presets.
OPERATIO N
LISTENING TO DAB RADIO
21
ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ