Datasheet

SPECIFICATION PAGE
TACT SWITCH 1 / 4
1. GENERAL
1.1 Application : This specification is applied to low current circuit tactile switch
for electronic equipment.
1.2 Operating temperature range : -20 ~ 70℃, 45 ~ 85% RH
1.3 Storage temperature range : -30 ~ 80℃. However, 96 hours maximum for continuous
storage over a range -20 ~ -30℃ and a range 70 ~ 80℃.
1.4 Test conditions : The standard test conditions shall be 5 ~ 35℃ in temperature,
45 ~ 85% RH and 860 ~ 1060mbar in atmospheric pressure.
Should any doubt arise in judgement, tests shall be conducted
at 20±2℃, 65±5% RH and 860 ~ 1060mbar.
2. RATED VOLTAGE AND CURRENT.
DC 12V 50㎃
3. ELECTRICAL PERFORMANCE
TEST CONDITIONS
Contact
arrangement
Contact Measured at DC 5V 100mA or by ohmmeter allowing
resistance a small current at 1㎑ with a load of twice
of the Actuating force.
3.3
3.4
3.5
APPD CHKD DSGN TITLE
DOCUMENT NO.
ZONESYMBDATEAPPDCHKDDSGD
Insulation
resistance
PROPERTY
DC 100V is applied between terminals and
between terminals and cover for 1minute
±5seconds.
AC 250V (50 ~ 60㎐)is applied between terminals
and between terminals and cover for 1 minute.
JT 0102LF
PERFORMANCE
* greater than 100㏁.
* less than 50mΩ.
* 1 pole, 1 throw.
Measured by lightly striking the center of the
button stem at a rate of 3 operations/sec…
3.1
3.2
* No insulation defect
shall be observed.
* less than 10 msec.
JTP1130,1230,1236
SERIES
Bounce
Dielectric
strength
PDF created with pdfFactory Pro trial version www.pdffactory.com