User Guide

Page
3-3-3-1 Switch Test
1. Select Switch Test from the ‘I/O Test’ menu. The following screen will
appear on the monitor.
Note:- On entering Switch Test the Skis will be unlocked. Ensure that the Skis
are returned to the locked condition at the end of the test by entering Motor
Test (See 3-3-3-2)
2. The word ‘ON’ will appear next to items (a) to (f) each time the respective
switch is operated.
When the skis are pushed left, ‘SWING-CENTRE’ will change to ‘LEFT’
and ‘OK’ will appear just before it reaches the extreme left,. When the skis
are pushed right, ‘CENTRE’ will change to ‘RIGHT’ and ‘OK’ will appear
just before it reaches the extreme right. ‘0000’ will increase when the skis
are moved to the right and decrease when they are moved to the left.
When the skis are tilted, ‘EDGE-CENTRE’ will change to ‘LEFT or RIGHT’
and ‘OK’ will appear just before they are fully tilted. ‘0000’ will change as
the skis are tilted.
SWITCH TEST
TEST SW ON .................(a)
COIN SW ON .................(b)
SERVICE SW ON .................(c)
R SELECTION BUTTON ON............(d)
DECISION BUTTON ON............(e)
L SELECTION BUTTON ON............(f)
SWING 0000 0000 CENTER .....(g)
EDGE 0000 0000 CENTER......(h)
L/R SELECT + DECISION : EXIT
13
Note: “EDGE” ‘OK’ will only appear if you
stand and apply weight to the edges
of the ski steps. There is no problem
if ‘OK’ is not displayed when stand-
ing on the steps in the same way as
normal play.
3. If ‘OK’ is not displayed when the edge is tilted left or right, re-initialize as
described in section 3-4 “Initialization”.
4. Operate both of the ‘Select L/R’ buttons and ‘Decision’ button together to
exit and return to the ‘I/O Test’ menu screen.