User Guide

Page
2-1 Fitting the Header Assembly
The Header Assembly has a forward centre of gravity, so it is important
that at least
two people are used to fit or remove the Header Assembly.
The fitting position of the Header Assembly is very high, and it is important that a
means of reaching the height safely, without stretching, is available. (e.g. steps,
step stools etc.)
1. Place the Header Assembly on to the monitor cabinet, connect the connectors
and pass the connectors in to the cabinet, slide the header back ensuring that it
engages fully in to the retaining brackets at the front of the monitor cabinet.
2. Fit the 2off M6x25 Hex Head Screws, Spring and Flat washers to retain the
Header Assembly to the cabinet.
5