User's Manual

Page 36
5-1 Fitting the Header Assembly
The Header Assembly has a forward centre of gravity, so it is important that at
least
two people are used to fit or remove the Header Assembly.
The fitting position of the Header Assembly is very high, and it is important
that a means of reaching the height safely, without stretching, is available.
(e.g. steps, step stool etc.)
1. Place the header assembly on to the monitor cabinet and connect the
connector.
2. Slide the header assembly back until it engages under the fixing brackets
on the top of the monitor cabinet.
3. Fit the 3off hex head screws (M6x16) to retain the header assembly in
place.