User's Manual

Page 40
11. Fit the connector cover using the 2off security screw (M5x12).
12. When the machine is in its final position, lower the fourteen level
adjusters, (6 on the monitor cabinet and 4 on each ride assy), with a
spanner so that the machine is level and all castors are raised from the
floor by approx. 5mm. Tighten the lock nuts with a spanner to ensure that
the level adjusters do not move.
Note: If the location site of this machine has a polished floor it is recommended
that rubber pads are fitted under the level adjusters to prevent the
machine sliding on the floor when in use.