User's Manual

Page 62
8-4 Replacing the Bike Potentiometer
1. Remove 3off security screw (M5x16) and remove the rear vac-form.
2. Disconnect the connector.
3. Slacken the grub screw (M4x6) and remove the potentiometer complete
with bracket.
4. Replace the potentiometer taking care to connect the correct colour wire
to the correct terminal.
When replacing the potentiometer ensure that the locating tab on the
potentiometer engages in the hole in the mounting bracket.
5. Refit the potentiometer and bracket, and tighten the grub screw (M4x6)
When refitting the potentiometer ensure that the grub screw engages on
the flat of the potentiometer shaft.
6. After replacing the potentiometer ensure that the game is
reinitialized. (see Section 7 page 56)