user manual

Page 4
2. MOVING THE MACHINE
This machine is fitted with castors to make it easier to move. Take care when
moving the machine on an inclined surface.
The overall height of the machine is 2080mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
3. INSTALLATION
WARNING  NEVER turn the power to the machine ON until installation
has been completed.
WARNING  In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
WARNING  So that customers are not injured , ensure that there is at
least 500mm separation between other machines or walls.
CAUTION  In order to avoid damage to the machine due to mis-operation,
ensure that the voltage of the mains supply is 230volts AC.
NOTE  If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters
to prevent the machine sliding on the floor.
 In order to gain access to the Power Supply and CPU assemblies,
make sure that the rear of the machine is separated from a wall
or other machine by at least 500mm.
This machine is designed for INDOOR USE ONLY.
Do not install in the following places.
1. Outdoors
2. Direct Sunlight, places with excessive humidity or dust, places where there is
water leakage, near air-conditioning or heating equipment, places with
excessive heat or cold temperature.
3. Places where it would be in the way of emergency exits or fire extinguishing
equipment.
4. Unstable places or places with excessive vibration.
5. Places that are not level.
6. This machine must not be cleaned with a water jet, or installed in an area where
a water jet could be used.