Phau Ntawv Qhia

Table Of Contents

W415-2920 / B / 04.26.22

ﬁ nishing

10.7 air ﬂ ow cover installation

Install one air ﬂ ow cover at each end of the burner stiffener rail (2 total)

using 4 screws (supplied).

The air ﬂ ow covers must be installed.

note:

• Electronic appliance temperatures must be validated at the time of installation as air ﬂ ow

characteristics within the room can vary and maximum acceptable operating temperatures can vary from

appliance to appliance. Electronic appliances cannot be used where the electronic appliance temperature

exceeds the manufacturer’s maximum allowable operating temperatures (see electronic appliance

manufacturer’s speciﬁ cations). Operating a television above the manufacturer’s maximum allowable

operating temperature will result in premature failure.

• Mantel height and depth must conform to mantel clearance requirements speciﬁ ed in this manual, see

“minimum clearance to combustible mantel” section in installation manual.

• Electronic appliance temperatures may be further reduced by increasing the horizontal distance between

the front of the electronic appliance and the front edge of the mantel or by increasing dimension “A” or “B”.

However, increasing the gap between the top of the mantel and the bottom of the electronic appliance

beyond the maximum recommended ﬁ gure, typically results in higher temperatures. Minimum clearance

between the mantel and bottom of the electronic appliance should be maintained to allow air circulation

below and behind the electronic appliance.

note: