Phau Ntawv Qhia

EN
W415-2920 / B / 04.26.22
59
maintenance
!
WARNING
• Risk of fire and electrical shock!
• Turn off the gas and electrical power before servicing this appliance.
• Use only Wolf Steel approved optional accessories and replacement parts with this appliance. Using
non-listed accessories (blowers, doors, louvres, trims, gas components, venting components, etc.) could
result in a safety hazard and will void the warranty and certification.
• Ensure that the fan’s power cord is not in contact with any surface of the appliance to prevent electrical
shock or fire damage. Do not run the power cord beneath the appliance.
• The wire harness provided in the blower kit is a universal harness. When installed, ensure that any excess
wire is contained, prevent it from making contact with moving or hot objects.
A. Turn off the power to the appliance.
B. Remove the safety barrier.
C. Unplug the blower from the junction box.
D. Raise the tab securing the blower assembly in place.
E. Lift the blower up from the slots.
F. Disconnect the slip-on connectors at the motor of the
blower.
G. Replace the blower in assembly and reverse previous
steps.
H. Ensure that there are no cables touching the blower.
Drywall dust will penetrate into the blower bearings,
causing
irreparable damage. Care must be taken to prevent drywall dust from coming into contact with the blower or its
compartment. Any damage resulting from this condition is not covered by the warranty policy.
12.5 blower replacement
Snap the lens out of the housing (including the metal bracket) (Fig. 2). Do not touch the halogen bulb with your
bare hands.
The oil from your fingertips will reduce the life of the bulb. With gloved hands gently pull the old bulb from the
socket and replace with the new bulb. Reinstall the lens, by snapping it back into the housing and bend the tabs
on the front of the housing back in to position.
Blower clips
(Fig. 2)
(Fig. 3)
Metal
bracket
Gloves