User Guide

NI cDAQ-9172 User Guide and Specifications 16 ni.com
6. Squeeze both C Series I/O module latches, insert the I/O module into
the module slot, and press until both latches lock the module in place.
7. Connect the NI cDAQ-9172 chassis with the supplied USB cable to
any available USB port on your computer.
8. Connect the power source to the NI cDAQ-9172 chassis. The
NI cDAQ-9172 chassis requires an external power supply that meets
the specifications in the Power Requirements section.
Note The NI cDAQ-9172 chassis uses a DC input jack with a locking ring. Use only this
connector with the NI cDAQ-9172 chassis. Refer to the Specifications section for more
information about the connector.
9. Secure the power supply and USB cables, as depicted in Figure 7,
using the two tie wraps and adhesive tie wrap mounts included in the
shipping kit. The tie wraps and adhesive mounts help secure the
non-latching USB connection. They can also be used to route the
cables to a desirable position.
Figure 7. cDAQ Chassis With Secured Cables
10. Power on the NI cDAQ-9172 chassis.
11. Double-click the Measurement & Automation icon, shown at left,
on the desktop to open MAX.
12. Expand Devices and Interfaces, and then expand NI-DAQmx
Devices.
NI cDAQ-9172