Computer Hardware User Manual

2.0 Quick Start

1. Install the CD into the CD drive of the computer

and install the SensorEval software (see Section

4.0).

2. Hookup the USB cable between the PC or

notebook computer and the LM95235EVAL

board as shown in Quick Start Diagram (See

Section 2.1).

3. Run the SensorEval software clicking the icon

on the desktop. The first screen after the

installation will look like this:

If not, select “Another Device”. The next screen

should look like this:

Select LM95235 and click on Open button.

4. The next screen (first screen after the first run of

the program) will look like this:

Select the LM95235 Evaluation Board.

Click OK.

5. The next screen will look like this:

Make sure that “4C” is selected in the upper left

box labeled “I2C Addr”. Select “All Regs” in the

“Read Cont” box to read all of the registers,

including the temperature registers continuously.