User Manual

LFO Controls Description
Phase Defines the initial phase of the LFO waveform, from -0.50 to 0.50.
Sync The Sync selector is used to synchronize the LFO with the tempo of
your Project. If Free is selected, the LFO rate is independent of the
Project tempo. If Retrig or Lock is enabled, the values of the Speed
parameter will change into note values ranging from 16/1 (= one
modulation cycle in 16 bars) to 1/32 (one cycle in 1/32nd note) and
be synced with the Project tempo. While Retrig restarts the LFO at
each new note (each note has another LFO phase), Lock keeps the
LFO phase synchronized to the song position for all notes.
DESTINATION
This is where you define modulation targets for the LFO, i.e. the parameters you want this LFO
to control. The knobs adjust the amount of modulation for the following targets:
Parameter Modulation Destination
Pitch Tune parameter of the PITCH / GATE section on the Pitch / Envelope
page (page 2).
Cutoff Cutoff parameter of the FILTER section (with filter types LP2, HP2,
BP2 only) on the FX / Filter page (page 3).
Drive Drive parameter of the FX section on the FX / Filter page (page 3).
Pan Pan parameter on the Audio page of the Sound’s Output properties
(see ↑11.1.2, Configuring the Main Output of Sounds and Groups for
more information).
Working with Plug-ins
The Sampler Plug-in
MASCHINE - Manual - 311