User Manual

Dragging vs. Nudging
Dragging with the mouse is different from the Nudge command on your controller:
▪ Whereas dragging is based on the Step Grid, the Nudge command is based on the Nudge
Grid (see section ↑10.1.7, Adjusting the Step Grid and the Nudge Grid).
▪ Whereas you can drag notes beyond the end of the Pattern, nudged notes reaching the end
of the Pattern are automatically sent to the beginning of the Pattern.
▪ If a note is not on a Step Grid division, dragging it with Step Grid enabled will alternate
between snapping to Step Grid divisions and snapping to positions that preserve its original
offset with the Step Grid (see quantization rule above).
In the software the Nudge command is not available with your mouse but via a keyboard short-
cut:
► Press [Alt] + the left/right cursor key on your computer keyboard to nudge the selected
notes by one Nudge Grid division. If no event is selected, all events in the Pattern will be
affected.
See the hardware section below for more information on the Nudge command.
Editing Selected Events/Notes on the Controller
Your controller provides various features in order to edit the events you have selected.
Editing Events and Notes via the Event Edit Mode
The Event Edit mode provides you with a few essential editing functions. These functions will
be applied to the current selection of events.
► Press EVENTS to enter Event Edit mode.
→ The EVENTS screen appears.
If your pads are in Group mode the Event Edit mode looks as follows:
Working with Patterns
Editing Events
MASCHINE - Manual - 472