User Manual

Off state (from 0 to 127, 0 by default), and On Value defines the value for the On state (0
to 127, 127 by default). For the Note message type, since the Off state is predefined (it’s
the MIDI Note Off message), you find instead a single Value parameter defining the veloci-
ty of the MIDI Note On message.
▪ Gate: This mode is equal to Toggle with the difference that the state is active for the time
the Pedal is held depressed. In Toggle mode the state is activated until the next time the
Pedal is pressed again.
▪ Trigger: In this mode, only one message is sent when you hit the control element. There are
no On or Off states. For example, this can be useful for switching to another program (pre-
set, patch…) or for triggering one-shot samples (e.g. drum sounds or any other envelope-
controlled sounds). In this mode, you thus find only one numeric field called Value, defin-
ing the value to be sent when you hit the control element. It goes from 0 to 127 (127 by
default).
▪ Inc: In this mode you can configure the press of a pedal to step through a list of values by
choosing the size of the jump (e.g. 1-2-3-4-5, 2-4-6-8-10 or 3-6-9-12-15), and whether or
not the values wrap around back to the beginning, or stop when they reach their minimum
or maximum.
9.7.7 Assignments for Pedals (Continuous)
For Pedals used as continuous control, the Type menu offers the entries Control Change and
Program Change. Depending on the selected entry, a different set of additional parameters is
available:
Type Mode Range Number
Control Change From 0-126 / To 1-127 0-127
Program Change From 0-126 / To 1-127
For Control Change, you can set the Range of values that is sent when pressing the pedal, and
the Number of the Control Change message. For Program Change, you can set the Range of
values that is sent when pressing the pedal.
Using the MIDI Assignment Editor
MIDI Message Types and Assignments
KOMPLETE KONTROL S-Series - Manual - 128