User Manual

1. Select the desired Group by pressing its Group button A–H. If your Project has more than
eight Groups, you can use Button 3 and 4 to first select the desired Group bank.
The selected Group button starts flashing and the corresponding Group is highlighted on
the left display.
2. Press Button 8 (APPLY) to export the Slices.
→
The Slices will be mapped to individual Sound slots, replacing their current content (if
any). Only the first 16 Slices will be exported. Your controller will leave Sample mode
and return to Control mode. The pads will switch to Group mode so that you can directly
play your Slices on the pads. Additionally, depending on the setting of the Pattern Crea-
tion selector in the Slice page of the software, notes will be automatically created for
each Slice (see below).
At any time you can press Button 7 (CANCEL) to cancel the export and return to the SLICE
page.
Exporting a Single Slice
Instead of exporting all Slices, you can also export the selected Slice only:
1. Press Button 7 (APPLY TO).
The controller switches to the Selection mode described above.
2. Press Button 5 (SINGLE) to export the selected Slice only.
3. Choose the target Sound or Group as described above.
4. Press Button 8 (APPLY) to export the selected Slice.
APPLY: Exporting the Slices to the Same Sound
►
On the SLICE page, press Button 8 (APPLY) to export all Slices to the focused Sound itself.
→
The Sample currently loaded in that Sound will be replaced by its own Slices, each of
them being mapped to a particular note.
This is equivalent to pressing Button 7 (APPLY TO) and selecting the Sound in which you already
are preparing the Slices.
Sampling and Sample Mapping
Slicing a Sample
MASCHINE STUDIO - Manual - 678