User Manual

These assignments aren't mutually exclusive, so you can send signal to either one or both FX
Units at the same time.
If you activate both FX assign buttons, your track will first run through FX1, then FX2.
TRAKTOR's FX only work if a channel is set to TRAKTOR mode. If you need to run an
external device through TRAKTOR's FX, set it to TRAKTOR mode and choose the Live
Input Deck flavor.
Assigning FX Units 3 and 4
TRAKTOR supports up to 4 FX Units. Activate the two additional FX Units in TRAKTOR's pref-
erences: Preferences > Effects > FX Unit Routing > 4 FX Units.
To assign a channel to FX Unit 3 or 4:
►
Press SHIFT + FX assign button. The left button assigns to FX Unit 3, the right one to FX
Unit 4.
►
Control FX Units 3 and 4 via S8's Performance knobs and buttons.
4.4.1.4 EQ Knobs
Each channel provides a 3-band EQ section: HI, MID and LOW knobs allow you to restore the
tonal balance between different tracks by increasing or decreasing the corresponding frequen-
cy band's volume.
Hardware Reference
The Mixer
TRAKTOR KONTROL S8 - Manual - 220