User Manual

► Set your sustain pedal to the ‘off’ or ‘non-pressed’ state when switching on the keyboard
to ensure the polarity is configured correctly.
If the sustain pedal acts inversely, you can correct the polarity by following the steps below:
1. Switch off the keyboard.
2. Set your sustain pedal to the ‘off’ or ‘non-pressed’ state.
3. Switch on the keyboard.
→ The correct polarity for your sustain pedal is set.
4.5 Connecting External MIDI Equipment to the Keyboard
The KOMPLETE KONTROL keyboard has dedicated MIDI sockets that allow you to directly
connect other MIDI devices using a 5-pin DIN MIDI cable and integrate the keyboard into your
MIDI setup.
The MIDI sockets on the rear panel of the KOMPLETE KONTROL keyboard.
To connect your external MIDI equipment:
1. Connect the device receiving MIDI signals to the MIDI OUT socket on the rear panel of
the keyboard using a 5-pin DIN MIDI cable.
2. Connect the device sending MIDI signals to the MIDI IN socket on the rear panel of the
keyboard using a 5-pin DIN MIDI cable.
→ The MIDI equipment is connected.
Depending on your use case, additional configuration is required in the software:
Setting up KOMPLETE KONTROL
Connecting External MIDI Equipment to the Keyboard
KOMPLETE KONTROL S-Series - Manual - 29