User Manual

▪ Relative (Offset): This mode is similar to the Relative mode explained above, with the differ-
ence that here the values sent for the “+1” and “-1” messages are 65 and 63, respectively
— in other terms, they are centered around 64 instead of 0. This is well suited for some
particular software implementations. As in Relative mode, a Step parameter defines the in-
crement to use, and a Resolution parameter adjusts the sensitivity of the control element
to your actions.
8.4.6 Assignments for Buttons
For the Buttons, the Type menu offers the entries Control Change, Program Change, and Note.
Depending on the selected entry, a different set of additional parameters is available:
Type Mode Value Number Note
Control Change Toggle Off/On 0-127 0-127
Trigger 0 - 127
Program Change Toggle Off/On 0-127
Trigger 0 - 127
Note Toggle 0 - 127 C-2 – G8
Gate 0 - 127 C-2 – G8
Mode Menu Values for Buttons
For the buttons control elements listed in the above table, and only for some of the MIDI mes-
sage types available for these control elements, you can choose from different behaviors for the
way the data is sent. This is controlled by the Mode menu. This menu can have up to four en-
tries, depending on the message type that you have selected in the Type menu. Here is the list
of all possible entries:
▪ Toggle: In this mode, the control element has two states, on and off. When you press once,
it switches to the on state — when you press again, it switches to the off state. For in-
stance, this can be useful for enabling and disabling an effect and check how it affects the
MIDI Communication
Using the MIDI Assignment Editor
KOMPLETE KONTROL S-Series - Manual - 103