User Manual

Element Description
Octaves Adjusts the spread of the arpeggiated sequence. You can choose to
play back your sequence within the octave of the click-pads you
pressed on your controller only, or you can select up to eight octaves
and let the notes of your chord (or a single note) be played back in as
many octaves.
OTHER
Dynamic Amplifies or reduces the velocity derived from the pressure you apply
on each single click-pad you hold (Polyphonic Aftertouch). Available
values range from 1% to 200%. This setting applies globally to all
rate presets.
Gate Adjusts the ratio between the duration of the notes and the duration
of the silences between them, measured as a percentage of the note
value set by Rate (see above in the RHYTHM section). Available
values range from 0% to 200%: At low values the notes are very
short. At 50% notes and silences are equal. At 100% (midcourse)
each note last exactly until the next note is triggered. At higher
values notes overlap (provided that the selected Sound is
polyphonic).
Lock Keeps the Arp feature enabled even when you leave Arp mode. For
example, this can be useful to adjust the chord settings, switch to
another Pattern, adjust Plug-in parameters, etc., while keeping
arpeggios running.
Hold The Hold function allows you to latch the notes played by the
arpeggiator. When set to On, the arpeggiator will continuously play a
sequence according to the last notes that were pressed.
To stop the arpeggiator playback, set the Hold parameter to Off.
SCALE
Recording and Editing Patterns
Creating Melodies and Harmonies
MASCHINE JAM - Manual - 106