Heritage Solar Lamp Post Instruction Manual 23108 Thank you very much for choosing a Nature Power product! For future reference, please complete the owner’s record below: Model: _______________ Purchase Date: _______________
Save the receipt and these instructions. It is important that you read the entire manual to become familiar with this product before you begin using it. This product is designed for certain applications only. The distributor cannot be responsible for issues arising from modification. We strongly recommend this product not be modified and/or used for any application other than that for which it was designed.
PARTS & HARDWARE LIST PART# A B C D E F G H I J K L-Q R S DESCRIPTION Lantern Assembly Lantern Top Lantern Body Lamp Post Base Upper Post Middle Post Lower Post Top Planter Base Bottom Planter Base Support Ring Lock Spring Screw Assembly J-Bolts Mounting Plate QUANTITY 1 3 3 1 1 1 1 1 1 1 3 24 3 1
ASSEMBLY Lamp Assembly 1. (SEE FIGURE 1) Insert the LED circuit wires of the lantern assembly (A) though the center of the lock spring (K) and lantern top (B). Thread the lantern top (B) to the assembly (A) and secure the top by turning clockwise to tighten. 2. Connect the LED circuit wires (input wires) found on the top of the lantern body (C) to the LED circuit wires (output wires) found on the bottom of the lantern top covers of the lantern assembly (A). 3.
Support Ring Assembly (SEE FIGURE 4) Attach the lower lamp post (G) to lamp post Base (D) using 1 in.screw (M) in 3 places. Insert the support ring over the lower lamp post and slide into place until it rests inside the planter base (H). Figure 4 LAMP POST ASSEMBLY 1. (SEE FIGURE 5) Attach lower lamp post (G) to lamp post base (D) using 1 in. Screw (M) in 3 places. 2. Place the completed lantern assembly (A) on the upper lamp post (E) and twist clockwise to secure.
CAUTION: To prevent product damage, and to prevent the product from tip-over, the planter base must be placed on a flat level surface. Fill with a minimum of 40 lbs of gravel or stone. INSTALLATION ALTERNATE GROUND MOUNTING Thread hex nut (O) onto the J-bolt (R). Make sure the Hex nut is threaded down the j-bolt far enough for the top the j-bolt to fit through the mounting plate (S) and the lamp post base (D) with enough threads to secure the base to the j-bolts with acorn nuts (P).
TROUBLESHOOTING If your solar light does not turn ON at dusk despite observance of all the instructions, please try the following steps: 1) Make sure the solar light is not being affected by any other light source; if this is the case move your solar light to a location where there is less light interference. 2) Make sure the solar light is not located in any shade during the day. 3) Make sure the switch is either in the “HIGH” or “LOW” position.