Nature's Generator Power Pod User Manual
Nature's Generator Power Pod Contents Important Safety Instructions Warning Caution 1 1 2 Introduction Unpacking Your Nature's Generator Power Pod Get to Know Your Nature's Generator Power Pod 3 3 4 Using Your Nature's Generator Power Pod How to Recharge Your Nature's Generator Power Pod How to Install Your Nature's Generator Power Pod on Top of Nature’s Generator How to Connect Your Nature's Generator Power Pod to the Nature’s Generator How to Maintain and Store Your Nature's Generator Power Pod 6 6 7
Important Safety Instructions 1. Read these instructions. 2. Keep these instructions. 3. Take note of all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Do not block any ventilation openings. 7. Do not use near flammable gases or fumes or other apparatus that produce a large amount of heat. 8. Only use attachments/accessories specified by the manufacturer. 9. Use only with the cart specified by the manufacturer, or sold with the apparatus.
Caution Damage requiring service Stop using the Nature's Generator Power Pod and refer servicing to qualified service personnel under the following conditions: • If liquid has been spilled or objects have fallen into your Nature's Generator Power Pod. • If your Nature's Generator Power Pod has been exposed to rain or water. • If your Nature's Generator Power Pod has been dropped or damaged in any way. • When your Nature's Generator Power Pod exhibits a distinct change in performance.
Introduction Congratulations on your new Nature's Generator Power Pod, a great expansion to your Nature’s Generator. Unpacking Your Nature's Generator Power Pod 1. Nature's Generator Power Pod 2. Accessory Box 3. This user guide Visit Naturesgenerator.
Get to Know Your Nature's Generator Power Pod Front Panel LED Light Button: Press it to show the battery charge l evel. LED Lights: When facing the front of the Nature's Generator Power Pod, from left to right: the first light will show green, which indicates a 20% charge.
Top Compartment Expansion cable: 35 inch long expansion cable. Visit Naturesgenerator.
Using Your Nature's Generator Power Pod How to Recharge Your Nature's Generator Power Pod Recharging from Solar Panels 1. Place your solar panel where it will get as much direct sunlight as possible. While direct sunlight is always preferred, solar panels should be connected at all times to provide a consistent trickle charge to your battery. Solar panels will also send a charge your unit while in hazy or overcast skies. 2.
How to Install Your Nature's Generator Power Pod on Top of Nature’s Generator What is in the accessory box 1. Brackets 2. Bolts and nuts A: 16mm x 2pcs B: 25mm x 2pcs 3. Power Pod Bar 4. Tools Visit Naturesgenerator.
Installing Procedures Step 1: Lift Nature's Generator Power Pod and set it on top of Nature’s Generator. Make sure the feet of Nature's Generator Power Pod sit between the handle and top case of Nature’s Generator. 8 Visit Naturesgenerator.
Step 2: Remove two bolts from Nature's Generator Power Pod with included the Allen wrench. Put these two bolts aside for now as they will be reused in step 5 below. Visit Naturesgenerator.
Step 3: Put the brackets on the cart. Bracket will match up with the shape of the cart frame. The curved part of the bracket should be placed on the back of the cart and the straight part of the bracket should be placed on the front of the cart. 10 Visit Naturesgenerator.
Step 4: Use type A bolts and nuts to secure the two brackets. Use wrench to hold the nuts the Allen wrench to tighten the bolts. A A Visit Naturesgenerator.
Step 5: Place power pod on the top of Nature's Generator Power Pod. Insert the bolts that were removed in step 2 by the Allen wrench. 12 Visit Naturesgenerator.
Step 6: Use the type B bolts and nuts to secure the brackets and power pod bar. Use the wrench to hold the nuts and the Allen wrench to tighten the bolts. B Visit Naturesgenerator.
How to Connect Your Nature's Generator Power Pod to Nature’s Generator You can connect your Nature's Generator Power Pod to your Nature’s Generator to extend the overall run time. 1. Open the top cover of the Nature's Generator Power Pod, locate the expansion cable, and run the expansion cable out of Nature's Generator Power Pod through the opening on the back of the Nature's Generator Power Pod. 2. Locate expansion port on the back of your Nature’s Generator and open the rubber cover. 3.
Technical Specifications Battery: Type: AGM Sealed Lead Acid Capacity: 100Ah (1200Wh) Self-discharge: Recommend to recharge it every 4 months Ports: 12V DC Port: up to 20A (240W max) Expansion Cable: 45 inches Charges: Solar Charger: 200watt Battery Level LED lights: 5 LED lights General: Dimensions: 18 x 12 x 15 in (47 x 30 x 38 cm) Operating temperature: 32-104 °F (0-40 °C) Storage Temperature: 23–111 °F (-5–45 °C) Weight: 92 lbs Visit Naturesgenerator.
Limited Warranty One Year Limited Warranty Huntkey USA Inc. warrants to you, the original purchaser of this new product, that the product shall be free of defects in the original manufacture of the material or workmanship for a period of one (1) year from the original date of your purchase of the product (“Warranty Period”). This product must be purchased from an authorized dealer and packaged with this warranty statement. This warranty does not cover refurbished product.
What does the Warranty not Cover? This warranty does not cover: • Cosmetic damage • Damage due to force majeure, such as lightning strikes, fire, flood, etc.. • Accident • Misuse • Abuse • Negligence • Commercial use • Modification of any part of the product • Damage due to incorrect operation or maintenance • Connection to an incorrect voltage supply • Attempted repair by anyone other than a facility authorized by Huntkey USA Inc.
Power Pod de Nature's Generator Manual del Usuario
Power Pod de Nature's Generator Contenido Instrucciones de Seguridad Importantes Advertencia Precaución 18 18 19 Introducción Desempaca el Power Pod de Nature's Generator Conoce el Power Pod de Nature's Generator 20 20 21 Usando el Power Pod de Nature's Generator Cómo Cargar el Power Pod Nature's Generator Cómo instalar el Power Pod de Nature's Generator encima del Nature's Generator Cómo conectar el Power Pod de Nature's Generator al Nature's Generator Cómo mantener y almacenar el Power Pod de Nature's
Instrucciones de Seguridad Importantes 1. Lee estas instrucciones 2. Guarda estas instrucciones. 3. Pon atención a todas las advertencias. 4. Sigue todas las instrucciones. 5. No uses este aparato cerca del agua. 6. No bloquees ninguna abertura de ventilación. 7. No lo uses cerca de gases flamables o humo o de algún otro aparato que produzca una gran cantidad de calor. 8. Solo usa los aditamentos/accesorios especificados por el fabricante. 9.
Precaución Daños que requieren servicio Deja de usar el Power Pod de Nature's Generator y remite el servicio al personal de servicio calificado bajo las siguientes condiciones: • Si se ha derramado líquido o han caído objetos en el Power Pod de Nature's Generator. • Si el Power Pod de Nature's Generator ha sido expuesto a la lluvia o el agua. • Si el Power Pod de Nature's Generator se ha caído o dañado de alguna manera. • Cuando el Power Pod de Nature's Generator muestra un cambio notable en el rendimiento.
Introducción Felicidades por tu nuevo Power Pod de Nature's Generator, una gran adición a tu Nature's Generator. Desempacando el Power Pod de Nature's Generator 1. El Power Pod de Nature's Generator 2. Caja de accesorios 3. Esta Guía del Usuario 20 Visita naturesgenerator.
Conociendo el Power Pod de Nature's Generator Panel Frontal Botón de luz LED: Presiónalo para mostrar el nivel de la batería. Luces LED: Viendo de frente Power Pod de Nature's Generator, de izquierda a derecha: la primera luz se mostrará en rojo, lo que indica una carga del 20%.
Compartimento Superior Cable de expansión: Cable de expansión de 35 pulgadas de largo. 22 Visita naturesgenerator.
Usando el Power Pod de Nature's Generator Cómo Cargar el Power Pod de Nature's Generator Cargando con Páneles Solares 1. Coloca tu panel solar donde reciba la mayor cantidad posible de luz solar directa. Si bien siempre se prefiere la luz solar directa, los páneles solares deben estar conectados en todo momento para proporcionar una carga de goteo constante a tu batería. Los páneles solares también enviarán carga a tu unidad mientras se encuentre en cielos nublados. 2.
Cómo instalar el Power Pod de Nature's Generator encima del Nature's Generator Qué está incluido en la caja de accesorios 1. Soportes 2. Tornillos y tuercas A: 16mm x 2 piezas B: 25mm x 2 piezas 3. Barra del Power Pod 4. Herramientas 24 Visita naturesgenerator.
Procedimientos de instalación Paso 1: levanta el Power Pod de Nature's Generator y colócalo sobre el Nature's Generator. Asegúrate de que los pies del Power Pod de Nature's Generator se encuentren entre el asa y la cubierta superior del Nature's Generator. Visita naturesgenerator.
Paso 2: Retira los dos pernos del Power Pod de Nature's Generator con la llave Allen incluida. Deja a un estos dos tornillos por ahora, ya que se reutilizarán en el paso 5 a continuación. 26 Visita naturesgenerator.
Paso 3: Coloca los soportes en el carrito. El soporte coincidirá con la forma del marco del carro. La parte curva del soporte debe colocarse en la parte posterior del carrito y la parte recta del soporte debe colocarse en la parte frontal del carrito. Visita naturesgenerator.
Paso 4: Utiliza tornillos y tuercas tipo A para asegurar los dos soportes. Usa una llave para sujetar las tuercas de la llave Allen para apretar los pernos. A A 28 Visita naturesgenerator.
Paso 5: Coloca la cápsula de poder en la parte superior del Power Pod de Nature's Generator. Inserta los tornillos que se quitaron en el paso 2 con la llave Allen. Visita naturesgenerator.
Paso 6: Usa los pernos y tuercas tipo B para asegurar los soportes y la barra de la cápsula de poder. Usa la llave para sujetar las tuercas y la llave Allen para apretar los pernos. B 30 Visita naturesgenerator.
Cómo conectar el Power Pod de Nature's Generator al Nature's Generator Puedes conectar el Power Pod de Nature's Generator a tu Nature's Generator para extender el tiempo de uso. 1. Abre la cubierta superior del Power Pod de Nature's Generator, ubica el cable de expansión y extiende el cable de expansión del Power Pod a través de la abertura en la parte posterior del Power Pod. 2. Localiza el puerto de expansión en la parte posterior de tu Nature's Generator y abre la cubierta de goma. 3.
Especificaciones técnicas Batería: Batería: Tipo: AGM Sealed Acid Capacidad: 100Ah (1200Wh) Autodescarga: Se recomienda recargar cada 4 meses Puertos: 12V Puerto DC: hasta 20A (240W máximo) Cable de Expansión: 35 pulgadas Cargas: Cargador solar: 200watt Luces LED del Nivel de la Batería: 5 luces LED General: Dimensiones: 18 x 12 x 15 pulgadas (47 x 30 x 38 cm) Temperatura de funcionamiento: 32-104 ° F (0-40 ° F) C) Temperatura de almacenamiento: 23–111 ° F (-5–45 ° C) Peso del producto: 92 libras 32 Vis
Garantía limitada Garantía limitada de un año Garantía limitada de un año Huntkey USA Inc. te garantiza a ti, el comprador original de este nuevo producto, que el producto estará libre de defectos en la fabricación original del material o mano de obra por un período de un (1) año a partir de la fecha original de compra de El producto ("Periodo de garantía"). Este producto se debe comprar en un distribuidor autorizado y se debe empaquetar con esta declaración de garantía.
¿Qué es lo que no cubre la garantía? Esta garantía no cubre: • Daños cosméticos • Daños debidos a causas de fuerza mayor, tal como rayos • Accidentes • Uso inapropiado • Abuso • Negligencia • Uso comercial • Modificación de alguna parte del Producto • Daño debido al uso o mantenimiento inapropiado • Conexión a una fuente de voltaje incorrecta • Intento de reparación por personal no autorizado por Dynex para reparar el Producto • Productos vendidos tal cual (en el estado en que se encuentran) o con todas sus
V2.0 ENGLISH 19-0603 V1.