Instructions / Assembly
How to Recharge Your Nature's Generator Power Pod
Recharging from Solar Panels
1. Place your solar panel where it will get as much direct sunlight as possible. While direct sunlight
is always preferred, solar panels should be connected at all mes to provide a consistent trickle
charge to your baery. Solar panels will also send a charge your unit while in hazy or overcast
skies.
2. Insert solar panel plug into Solar Input port on the front of Nature's Generator Power Pod.
You will know it is recharging when LED lights start running. The LED lights remain solid when the
baery is full or there is not enough power from solar panel.
3. It takes about 15 to 20 hours to recharge Nature's Generator Power Pod if using 100 wa solar
panel, and also depends on the the strength of the sunlight.
4. To increase the recharging speed, you can daisy chain mulple solar panels in parallel connecon.
The Solar Input port can handle up to 200 wa solar panel. Visit Naturesgenerator.com for
informaon on purchasing addional solar panels.
Recharging from Nature's Generator
1. Connect Nature's Generator Power Pod to Nature’s Generator (not included in the box) by the
expansion cable.
2. When Nature’s Generator is being recharged by solar, wind or wall, Nature's Generator Power
Pod will be recharged at the same me.
3. The LED lights do not run while Nature's Generator Power Pod is recharged from Nature’s
Generator, but you can press the LED Light Buon to check baery level.
Using Your Nature's Generator Power Pod
6 Visit Naturesgenerator.com for More Information