Full Product Manual
MAINTENANCE
Your Nature’s Wind Turbine has been designed to run for long periods without requiring any
maintenance. Performance will be enhanced if you periodically inspect your system. Review the
following simple maintenance procedures and implement every six months.
Cauon: Do not go near the wind turbine during operaon.
• Check blades for superficial damage. Replace blades if damaged. It is important not to use
blades that are damaged, as you will lose overall balance, resulng in a decrease in efficiency.
Should you noce damage to the blades, you must replace all 5. The blades are balanced as sets.
• Check the blade bolts and the nut for ghtness.
• Check nose cone for cracks and ghten nuts.
• Wipe any excess dirt build-up from blades.
• Check electrical connecons to make sure they are ght and free from corrosion.
Trouble shoong
Cauon: You may require an extra person to assist with these tests.
1. Remove the blade and hub from your Nature's Wind Turbine.
2. Drain your Nature’s Generator to show only one bar or two bars of baery level.
3. Connect your Nature’s Wind Turbine to your Nature’s Generator. And make sure your Nature's
Generator main power is switched off.
4. Set your power drill at speed mode and use an 8mm hex drive bit (not included, please
purchase separately) to spin the rotor sha.
5. You will see the LCD display on your Nature's Generator lights up and then your wind turbine icon
illuminates and the baery bar starts running. It means your Nature’s Wind Turbine should be
recharging your Nature’s Generator fine. You should also feel resistance on the rotor sha.
If you have any quesons on the trouble shoong procedures, please do not hesitate to contact
our Customer Support line at 805-383-0003 or email us at support@naturesgenerator.com .
14
Visit NaturesGenerator.com for More Information