User's Manual

14. Install (1) Bottom Swing Arm Shaft into the swing arm and the install the foot support tube (see Figures 2 and 3).

15. Install and tighten (1) 1/2”-13 hex head screw, (2) 1/2” washers, and (1) 1/2”-13 nuts connecting the swing arm and

the foot support tube (both left and right sides). This will require a 3/4” hex socket wrench. Install nuts toward

middle of the machine as is shown in Figure 2. Torque bolts to 45 ft/lbs (if torque wrench is available).

16. Repeat steps 14 and 15 for the opposite foot support tube.

SWING ARM

1/2” FLAT

WASHER

1/2”-13 HEX

HEAD SCREW

(2X) PLASTIC BUSHING

(FACTORY INSTALLED)

FOOT SUPPORT

TUBE

1/2”-13

NUT

1/2” FLAT

WASHER

SWING ARM

SHAFT

Figure 2

Figure 3

1/2”-13 Nut

Swing Arm

Foot Support Tube

Swing Arm Shaft

1/2” Flat Washer

EV916 ONLY:

Wire Connection

1/2”-13 Hex Head Screw

CommElliptical_AM_0805.indd 7 9/27/2005 10:26:49 AM