Operation Manual

8120 Installation and Operation Manual77
Connect the transducer to the blue Instrument
connector; tighten the locking collar.
During setup
a) set Sonar to (see section 17-1)
b) set up the sonar options (see section 17-3)
Sonar cable
18-7 Installation: Navman petrol/gasoline sensors
Fit the optional petrol/gasoline fuel kit
following the instructions supplied with the kit.
Note:
SmartCraft engines have fuel flow sensors,
therefore Navman fuel sensors are not
required as well.
For dual engines, fit two kits.
Wire the Instrument for auto power (see
section 18-4).
During setup:
a) set the fuel data (see section 17-5)
18-8 Installation: Navman diesel sensors
Fit the optional diesel fuel kit following the
instructions supplied with the kit. Note:
SmartCraft engines have fuel flow sensors,
therefore Navman diesel sensors are not
required as well.
For dual engines, fit two kits. Wire the two
diesel flow sensor cables in parallel.
Normally, power the diesel sensors
from the boat ignition switch. Then the
Instrument does not need to be wired for
auto power (see section 18-4).
During setup:
a) set NavBus to (see section 17-10)
b) set the fuel data (see section 17-5)
Blue
Fuel sensor cable
Diesel sensor cable
White
White