Operation Manual

8120 Installation and Operation Manual8
1-4 Removing and replacing the display unit
If the 8120 is bracket mounted then it can
easily be removed for security.
Removing the display unit:
1 Turn the 8120 off (see section 2-2) and put
the dust cover on.
2 Loosen the knobs on the mounting
bracket and lift the unit off the bracket.
3 Unplug the connectors from the 8120; turn
each locking collar anticlockwise until you
can pull the plug out.
4 Store the 8120 in a dry clean place.
Replacing the display unit
1 Plug the connectors into the back of the
display unit:
Match the connector’s colour to the
socket colour.
Insert each connector and turn the
locking collar clockwise until it is finger
tight.
Nothing will be damaged if a cable is
plugged into the wrong socket by mistake.
2 Hold the 8120 in place on the mounting
bracket. Tilt it for best viewing, then
hand tighten the knobs on the mounting
bracket. Remove the dust cover.
Mounting
bracket
Knob