Operation Manual

8120 Installation and Operation Manual86
i Electrical noise from the boats engine or
an accessory may be interfering with the
transducer(s) and/or the Instrument. This
may cause the Instrument to automatically
decrease the Gain unless using Manual
Gain.
The Instrument thus eliminates weaker
signals such as fish or even the bottom
from the display. This may be checked
by switching off other instruments,
accessories (e.g. bilge pump) and the
motor until the offending device is
located. To stop problems from electrical
noise, try:
- re-routing the power and transducer
cable(s) away from the boat’s other
electrical wiring.
- routing the display units power cable
directly to the battery with an in-line
fuse.
4-2 Bottom is not displayed:
a The Instrument may have Manual Range
selected and the depth may be outside
the range value selected. Either change
the Instrument to Auto Range or select
another depth range (see section 8-5).
b The depth may be outside the Instrument’s
range. While in Auto Range, the display unit
will display “--.-” to indicate that there is no
bottom detected. A display of the bottom
should reappear when in shallower water.
4-3 The bottom is displayed too far up
the screen:
The Instrument may have Manual Range
selected and the selected Range value
is too high for the depth. Either change
the Instrument to Auto Range or select
another depth range (see section 8-5)
4-4 Bottom echo disappears or erratic
digital reading while the boat is moving:
a Ensure the back of the bottom surface
of the transducer is slightly lower than
the front and the front is as deep in the
water as possible in order to minimise
the generation of bubbles through
cavitation. (See the Transom Transducers
Installation Guide, for more information.)
b The transducer may be in turbulent
water. Air bubbles in the water disrupt
the echoes returned, interfering with the
Instruments ability to find the bottom or
other targets. This often happens when
the boat is reversed. The transducer must
be mounted in a smooth flow of water in
order for the Instrument to work at all boat
speeds.
c Electrical noise from the boats motor can
interfere with the Instrument. Try some
suppression spark plugs.
4-5 There is a double bottom trace
displayed:
a The boat may be in an area that generates
shadows (see section 8-2).
b In shallow water, the echoes may bounce.
Reduce the gain setting (see section 8-6)
and/or reduce the sonar pulse power (see
section 17-3).
c Decrease the Range.