- NDC Wireless Access Point User's Guide

28 InstantWave High Rate 11Mbps Access Point
The menu offers configuration options that enable you to tailor your network to
suit your needs.
AP Settings - sets the AP’s IP related parameters, sets filters, sets wireless
related parameters, sets AP Access Control list
Trap Management
Load Factory Configuration
Upgrade AP Firmware
Reset AP
AP Settings
Click AP Settings to open the AP Settings dialog box (Figure 26).
Figure 26. AP Settings/IP
IP:
From the IP card you may view or modify the Access Point’s TCP/IP address,
configure its subnet mask, or add a default gateway (see the following note).
Note: An AP will transfer SNMP respond packets (confirmation packets) to its
APMS PC directly if it is within the same LAN (the same subnet mask). If an
SNMP respond packet from an AP is destined for an APMS PC on another