- NDC Wireless Access Point User's Guide

32 InstantWave High Rate 11Mbps Access Point
Note: Do not set all the stations in the Access Control table to Read. Once this is
set and enabled, it will be difficult to modify the AP. Should this situation
occur, use the AP COMFig utility to re-set the configuration.
Two levels of access are available. To set access rights, enter a station’s IP address
and community string (the community string must be the same as the AP’s in the
Host Table of the APMS manager terminal, i.e. the PC running APMS) and choose
Read or Read/Write.
Read Read-only rights. The user may read everything
except the Access Control settings, but cannot
alter anything
Read/Write The user may read and alter all settings
The Add button will become active. Click Add to add the information to the AP
Access Control table. Click another tab to continue configuration setting or click
OK to complete the AP setting. Click the Config/Reset AP menu item to make the
changes effective.
MAC Access Control:
Limit access rights to this Access Point. You may enter up to 1000 stations
(identified by their MAC addresses) into the list.
Figure 30. AP Setting/MAC Access Control