User's Manual

CHAPTER 3 NDA-24300
Page 232
Issue 1
SYSTEM MESSAGES
➂
Alarm-detected HW
Note:
This data displays only when b4 is “1” and b3 is “0” in data
➁
.
Repair Procedure
Basically, fault repair work is not required by the display of this message. However, if the message is created
frequently, it is recommended that the repair work be performed as shown in the message [33-C] SDT Alarm
Trouble.
b7 b6 b5 b4 b3 b2 b1 b0
The data here specifies the HW, on which any of the VC-11 Path
Trouble was detected in data
➁
(see Note). Refer to the table below:
b7 b6 b5 b4 b3 b2 b1 b0
- - - - 28 27 26 25
24 23 22 21 20 19 18 17
16 15 14 13 12 11 10 9
87654321
0/1=-/VC-11 Path Trouble