User's Manual

NDA-24300 CHAPTER 4
Page 247
Issue 1
UNIT/CIRCUIT CARD REPLACEMENT PROCEDURE
STEP 4 After turning “ON” the MBR key on the DSP of the new CPR, insert the
new CPR into the LPM. Then, fasten the retained four screws. (Refer to
Figure 4-7)
Figure 4-7 Accommodation of New CPR into LPM
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
CPR
LPM
As shown in Figure 4-7, insert the new CPR into the LPM. Then, fasten the four screws.