User's Manual

CHAPTER 4 NDA-24300
Page 254
Issue 1
UNIT/CIRCUIT CARD REPLACEMENT PROCEDURE
Circuit Card Installation Into New CPR
This procedure shows how to install the new CPR into the LPM.
(1) Detach the front panel of the new CPR by using the Phillips screwdriver to remove
the four screws, as shown in Figure 4-9. Then, lift the top cover by removing the
eight screws.
Figure 4-9 Removal of Front Panel and Top Cover From CPR
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
As shown in the figure below, detach the front panel of the new CPR by removing the 4 screws.
Then, also lift away the top cover by removing the 8 screws.
Top Cover
CPR
Front Panel