User's Manual

CHAPTER 6 NDA-24300
Page 440
Issue 1
SYSTEM OPERATIONS
(3) Designated Connection Test Procedure
(a) Register Test Procedure
Figure 6-29 Register Test Procedure/Connection Diagram
• Access code is assigned by ASPA command, CI=N,
SRV=SSC, SID=17
• Route numbers to be designated are as follows.:
• If any of the dialed numbers are not received correctly, a
Reorder Tone (ROT) is heard.
RT NUMBER
902
903
TRUNK NAME
Originating Register Trunk
Incoming Register Trunk
Hang Up
TRUNK DESIGNATION TEST IN PROGRESS
REGISTER
UNDER TEST
ORT
Note:
If the trunk number of the next register is not assigned, the test ends.
Lift handset
(DT)
Dial access code for
designated connection
“9xx + “xxx”
RT No. TRK No.
(DT)
Dial “1,2,3,4,5,6,7,8,9,0” (*, #
in case of PB signal)
consecutively
(
SST
)
Is next register to
be tested, too?
(NO)
(YES)
Make switch hook flash
Note