User's Manual

NDA-24300 CHAPTER 6
Page 441
Issue 1
SYSTEM OPERATIONS
(b) Sender Test Procedure
Figure 6-30 Sender Test Procedure/Connection Diagram
• Access code is assigned by ASPA command, CI=N,
SRV=SSC, SID=17
• Route number to be designated is as follows:
• If any of the dialed numbers are received correctly, a Reorder
Tone (ROT) is heard.
RT NUMBER
905
TRUNK NAME
Sender Trunk DP/PB
Hang Up
Note 1:
After the sender to be tested is connected to the register, the sender sends out 1 ~ 9, 0 by DP
signals and 1 ~ 9, 0, *, # by PB signals, thus checking to see if the dialed numbers are sent out
correctly.
Note 2:
If the trunk number of the next sender is not assigned, the test ends.
+“9xx”
RT No.
“xxx”
TRK No.
Lift handset
Connection test is automatically
Is next
performed
Note 1
register to be
tested, too?
Make switch hook flash
Note 2
(DT)
Dial access code for
designated connection
(Music On Hold)
(SST)
TRUNK DESIGNATION
MUSIC ON
HOLD
ORT
SND
TEST IN PROGRESS
ORT
DP
OR PB
YES
NO