User's Manual

CHAPTER 6 NDA-24300
Page 458
Issue 1
SYSTEM OPERATIONS
To perform ACT/STBY system changeover, check the lamp indicators shown in Figure 6-39, and then
operate the related key.
Note:
LED indications cited in Figure 6-39 are only an example. The indicating patterns (ON/Flash/OFF)
can differ, depending on each system setting.
Figure 6-39 How to Check LEDs and SW Keys for System Changeover (IMG1)
13 14
MUX(PH-PC36) MUX(PH-PC36)
13 14
MUX(PH-PC36) MUX(PH-PC36)
13 14
MUX(PH-PC36) MUX(PH-PC36)
MUX(PH-PC36) MUX(PH-PC36)
13 14
08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
DLKC (PH-PC20) DLKC (PH-PC20) GT (PH-GT09) TSW 00 (PH-SW12) TSW 01 (PH-SW12) TSW 02 (PH-SW12) TSW 03 (PH-SW12) TSW 10 (PH-SW12) TSW 11 (PH-SW12) TSW 12 (PH-SW12) TSW 13 (PH-SW12) PLO Note 1 PLO Note 1
(RES)
GT (PH-GT09)
TOPU
PIM3
PIM2
PIM1
PIM0
TSWM
BASEU
FANU
FRONT VIEW
: Lamp is ON : Lamp is OFF
Legend
IMG1
System State
TSW 0 -> ACT
PLO 0 -> ACT
DLKC 0
-> ACT
MUX
FRONT
MUX ACT
MB
DLKC
FRONT
OPE/MB
MB
PLO
FRONT
TSW
FRONT
TSW ACT
MB
TSW MBR
GT
FRONT
OPE/MB
MB
MBR
ACT
MB
Note:
Use any of the following circuit cards: PH-CK16, PH-CK17, PH-CK16-A, PH-CK17-A