User's Manual

CHAPTER 6 NDA-24300
Page 484
Issue 1
SYSTEM OPERATIONS
12.2.4 System Initialization by Keys on CPU Front Panel
This initialization executes when the INITIAL key on the TOPU cannot be used.
The CPU’s active status must be confirmed before executing this type of initial-
ization. Perform the procedure in Table 6-17.
Table 6-17 System Initialization by Keys on CPU Front Panel Procedure
ACTION REMARKS
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
Use ATIM command to adjust date and
time. (Refer to Chapter 8)
Confirm ACT0 lamp lights
green again.
Confirm ACT1 lamp lights
green again.
Press CPU RST key on the
DSP of CPU #0.
Press CPU RST key on the
DSP of CPU #1.
Confirm SENSE switch on the
DSP of CPU #1 is 2 (DM Load
Restart).
Confirm SENSE switch on the
DSP of CPU #0 is 2 (DM Load
Restart).
ACT0 lights green.) (ACT1 lights green.)
Check ACT0/ACT1
lamps on the EMA
card.
START
(CPU #0 is being initialized.)
(CPU #1 is being initialized.)
END
EMA: PH-PC40