User's Manual

NDA-24300 CHAPTER 6
Page 491
Issue 1
SYSTEM OPERATIONS
CPU OPE and IMGX lamps on
both DSP go OFF.
STATUS LED (right) on
the DSP of CPU is ON.
STATUS LED (right) on
the DSP of CPU is ON.
STATUS LED (right) on
the DSP of CPU is ON.
CPU OPE lamp on the
DSP of active CPU
lights steady-green. IMG0-3
lamps flash.
IMG0 lamp on the DSP of mate
CPU flashes green.
STATUS LED (right) on
the DSP of CPU is ON.
(ON LINE)
Table 6-20 Start-Up When Basic & Application Software Is
Installed [Procedure #1] (Continued)
ACTION
7SEG LED/OPE LAMP/KEY
SETTINGS
Back up Office Data using the MEM_HDD command.
Set the keys on the TOPU as follows.
• PROGRAM KEY → NON LOAD
• SYSTEM DATA KEY → LOAD
Set SENSE switch at “2” (DM Load Restart) on the DSP of active
CPU.
Press INITIAL START button on the TOPU.
• HD Initial
• DM Load
• System Initial
• System starts up again.
Enter your Office Data.
END
A
Turn ON the EFFECT key on the TOPU. (See Figure 6-58)
ATTENTION
Contents
Static Sensitive
Handling
Precautions Required
LOAD
NON LOAD
PROGRM
NON LOAD
SYSTEM DATA
LOAD
PZ-DK222